09 × 10−2, and 1.10 × 10−2 min−1 when the temperatures were 15°C, 25°C, and 35°C, respectively. From the selleck chemicals llc Arrhenius plot as shown in the inset of Figure 6, the activation energy was determined to be 1.37 kJ/mol. Such a low value accounted for the weak temperature dependence. Figure 6 Effect of temperature

on photocatalytic degradation of R6G in the visible light region by ZnO-H@Ag. Initial R6G concentration at 10−5 M. The inset is the corresponding Arrhenius plot. R6G was chosen as the target for the study on the SERS property. Its characteristic peaks included 611, 772, 1,178, 1,304, 1,360, 1,503, 1,569, and 1,645 cm−1. Figure 7 shows the SERS spectra of 10−9 M R6G on ZnO@Ag, ZnO-A@Ag, and ZnO-H@Ag (i.e., the photo-reduction deposition of Ag nanoparticles was repeated for three times). It was obvious that under such a low R6G concentration, the SERS spectrum could be observed clearly only on the ZnO-H@Ag. According to the previous work, Ag nanoparticles exhibited plasmon resonance upon the illumination of visible light, which enhanced the electric fields between nanorods, and thus there formed lots of ‘hot spots’ to enhance the SERS performance [35]. Three kinds of hot spot could be caused: (1) between the Ag nanoparticles on the side surface of the same nanorod, (2) between the two Ag nanoparticles on the side surface of two neighboring nanorods, and (3) between the two Ag nanoparticles on the tops of two neighboring nanorods [35]. In

this work, Ag nanoparticles were uniformly deposited on the top, side, and bottom of the ZnO nanorods for ZnO-H@Ag, which possessed Smoothened Agonist concentration all the above kinds of hot spots and exhibited the best SERS property. ZnO@Ag had small and little Ag deposition only on its top, which barely formed any kind of hot spot and therefore its SERS property was poor. For ZnO-A@Ag, the deposition Lonafarnib research buy of lots of Ag nanoparticles led to the structural destruction of ZnO 7-Cl-O-Nec1 purchase nanorod arrays, which could not form effective electric fields and therefore, its SERS property was also poor. Figure 7 SERS spectra of R6G on ZnO@Ag, ZnO-A@Ag, and ZnO-H@Ag.

R6G concentration at 10−9 M. Moreover, using the ZnO-H@Ag obtained by changing the repeating time to 2 or 4, the intensity of SERS spectra was decreased as indicated in Figure 8. This revealed that the ZnO-H@Ag obtained at a repeating time of 3 was the better substrate for the SERS application. When the repeating time was 2, fewer hot spots would be formed because of the presence of less Ag nanoparticles. When the repeating time was 4, the slight agglomeration of Ag nanoparticles occurred (particularly on the tops of nanorods) and led to the decrease of SERS intensity. Accordingly, the ZnO-H@Ag obtained at a repeating time of 3 was further used for the SERS analysis of R6G at different concentrations (10−6 ~ 10−10 M). As shown in Figure 9, when R6G decreased from 10−6 to 10−9 M, the main characteristic peaks at 611, 772, and 1,360 cm−1 still could be observed.